Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
experimentation
Author Message
gords1001 Offline
Sir Gords - Slayer of Joose !
*****

Posts: 1,937
Likes Given: 500
Likes Received: 1,035 in 654 posts
Joined: Aug 2013
Reputation: 9
Post: #1
experimentation
[Image: 20140517_103339_zpsyhxpeu5g.jpg]

I'm aiming for .2ohm and I have 1.8ohm res no res set ups.
17-05-2014 09:57 AM
Find all posts by this user Like Post Quote this message in a reply
the little puffer Offline
Junior Member
**

Posts: 28
Likes Given: 0
Likes Received: 10 in 7 posts
Joined: Dec 2013
Reputation: 2
Post: #2
RE: experimentation
what wire have you used for the negitive loop?
17-05-2014 10:19 AM
Find all posts by this user Like Post Quote this message in a reply
Spasmod Offline
Administrator
********
Administrators

Posts: 5,634
Likes Given: 8,594
Likes Received: 5,785 in 2,980 posts
Joined: Aug 2013
Reputation: 102
Post: #3
RE: experimentation
I don't have a clue what you're doing but it looks like a good plan Tongue

Popcorm1
17-05-2014 10:59 AM
Find all posts by this user Like Post Quote this message in a reply
gords1001 Offline
Sir Gords - Slayer of Joose !
*****

Posts: 1,937
Likes Given: 500
Likes Received: 1,035 in 654 posts
Joined: Aug 2013
Reputation: 9
Post: #4
RE: experimentation
Paper clip, next to zero resistance. Think the first experiment wont work, traditional wraps on silica take up too much room, next experiment is micro coils and cotton
17-05-2014 11:52 AM
Find all posts by this user Like Post Quote this message in a reply
Spasmod Offline
Administrator
********
Administrators

Posts: 5,634
Likes Given: 8,594
Likes Received: 5,785 in 2,980 posts
Joined: Aug 2013
Reputation: 102
Post: #5
RE: experimentation
[Image: homemade-firework-fail-o.gif]
17-05-2014 12:00 PM
Find all posts by this user Like Post Quote this message in a reply
[-] The following 3 users Like Spasmod's post:
BOB (05-17-2014), Galaxyrider (05-20-2014), JohnnyMac (05-17-2014)
the little puffer Offline
Junior Member
**

Posts: 28
Likes Given: 0
Likes Received: 10 in 7 posts
Joined: Dec 2013
Reputation: 2
Post: #6
RE: experimentation
are you going to fit 4 wires in each positive hole or use a loop again?

ive seen a simular 8 coil setup. looks mint lol
(This post was last modified: 17-05-2014 12:28 PM by the little puffer.)
17-05-2014 12:27 PM
Find all posts by this user Like Post Quote this message in a reply
gords1001 Offline
Sir Gords - Slayer of Joose !
*****

Posts: 1,937
Likes Given: 500
Likes Received: 1,035 in 654 posts
Joined: Aug 2013
Reputation: 9
Post: #7
RE: experimentation
There's three in there now, had to break off for family stuff, I'll post a picture later.
17-05-2014 02:47 PM
Find all posts by this user Like Post Quote this message in a reply
gords1001 Offline
Sir Gords - Slayer of Joose !
*****

Posts: 1,937
Likes Given: 500
Likes Received: 1,035 in 654 posts
Joined: Aug 2013
Reputation: 9
Post: #8
RE: experimentation
So I ended up with this.

[Image: 20140517_181542_zpsdqbxfdvj.jpg]

[Image: 20140517_185108_zpsnhj9w46h.jpg]

[Image: 20140517_185114_zps37aevnek.jpg]

Simple fact is, the results were far exceeded by the effort required. I vaped it a bit then ripped it out and did this

[Image: 20140517_210139_zpseqvhzs34.jpg]

Which gives far better results and took about ten minutes lol.

It was a worthwhile exercise, but certainly not something you would choose to do again.

Still, at least I can say I built an octocoil set up now.
17-05-2014 08:07 PM
Find all posts by this user Like Post Quote this message in a reply
[-] The following 2 users Like gords1001's post:
BOB (05-18-2014), Spasmod (05-18-2014)
JohnnyMac Offline
The Mac Daddy!
********
Administrators

Posts: 1,513
Likes Given: 1,217
Likes Received: 1,318 in 683 posts
Joined: Aug 2013
Reputation: 8
Post: #9
RE: experimentation
ROFL!  What the hell did I just see??? Shok

We need some better pictures of that crazy shit you just made.  I don't even know how it worked or what it was doing but it freaking worked!  LOL  How long until Rip Tripper is making a video of that claiming he invented the new "Angry Squid" coil?  Rofl
17-05-2014 11:34 PM
Visit this user's website Find all posts by this user Like Post Quote this message in a reply
[-] The following 3 users Like JohnnyMac's post:
BOB (05-18-2014), gords1001 (05-18-2014), Spasmod (05-18-2014)
gords1001 Offline
Sir Gords - Slayer of Joose !
*****

Posts: 1,937
Likes Given: 500
Likes Received: 1,035 in 654 posts
Joined: Aug 2013
Reputation: 9
Post: #10
RE: experimentation
The paper clip rails are negative connections. The positive legs go in the centre post.

I may experiment again with vertical coils made of .2 kanthal but I pulled the build pretty quick as there just wasnt the space for airflow. One trick might be to pad cotton around the coils so the air passes through them.
18-05-2014 08:01 AM
Find all posts by this user Like Post Quote this message in a reply
Post Reply