coil winder

[BOB]

I saw a coil winder on the fast tech interesting new products page and thought I would try and make one to see what they are like
I don't know the size of the original but the one I made is handheld 4 inch long 2 inch high and an inch and a half thick
it will take up to a 5mm drill bit or screwdriver that clamps in with a bolt
the other bolt is  to clamp the kanthal
I can tighten the bolts finger tight and they grab the bit and the wire
I also stuck a 510 connector in the side to screw your atty on
it took me about half an hour to make and didn't cost anything as I had the bits and bobs I needed
basically its a clamp to hold your drill bit and kanthal in place while you wrap your coil

[Spasmod]

LOL Bob.. you never cease to amaze me  such a simple yet brilliant tool

Nice idea about putting the 510 in there for building on 

[Don]

Nice work Bob!